NOTIFIER ISO-X Fault Isolator Module for SLC Loops
In stock — ships within 1 business day via FedEx
Manufacturer warranty
Notifier warranty
Term 36 months from date of manufacture
Notifier products are covered by Honeywell's Fire Products Standard Limited Warranty against defects in materials and workmanship. Products are date-stamped at manufacture. Software, batteries and other consumables are not covered. Honeywell repairs, replaces or credits defective units through its RMA process.
RMA help from Plena Supply
Need a return or replacement under warranty? Contact Plena Supply with your order number and the item's serial/date code, and we'll guide you through the RMA process.
Warranty terms are set by the manufacturer and can vary by product, date code and purchase channel.
The NOTIFIER ISO-X Fault Isolator Module is used with Notifier ONYX® and CLIP series fire alarm control panels to protect the system against wire-to-wire short circuits on the SLC loops.
Isolators are spaced between groups of devices on a loop. If a short occurs between two isolators, both switch to an open-circuit state and isolate that section while the rest of the loop keeps operating. The module automatically restores the shorted portion when the short is removed. In Style 4 loops it is generally used at each T-tap branch.
Key Features
- Powered directly by the SLC loop, no external power and no address required
- Opens the SLC automatically on detection of a short (line voltage below 4 V) and resets automatically when corrected
- Supports Style 4, 6 or 7 wiring
- Integral yellow LED pulses in normal condition, steady when a short is detected; wide viewing angle
- High noise (EMF/RFI) immunity; SEMS screws with clamping plates
- Mounts on a standard 4" square junction box at least 2-1/8" deep; surface-mount box optional
- Maximum 25 devices between isolators (B224RB relay base counts as 2.5 devices)
- Manufacturer: Notifier | Part Number: ISO-X | Condition: New
Always verify compatibility with your system and local code requirements before ordering.
Technical Specifications
Manufacturer: Notifier (Honeywell)
Model: ISO-X (ULC version: ISO-XA)
Operating Voltage: 15 to 32 VDC (peak)
Standby Current: 450 µA (not isolating)
Maximum Current Draw: 17 mA (in isolation, LED latched)
Temperature: 32°F to 120°F (0°C to 49°C)
Humidity: 10% to 93% RH, non-condensing
Dimensions: 4.5" H × 4.5" W × 0.25" D
Weight: 5 oz (150 g)
Listings: UL S635; ULC S635 (ISO-XA); FM Approved; CSFM 7165-0028:0214, 7165-0028:0224 (see data sheet for full list)